IMPORTANT: Repeat this every 30 minutes for at least two hours. Stop PoolMon, wait for a 30 minutes, and then restart PoolMon.Let PoolMon run for at least few hours, sometimes it might need to run for few days. IMPORTANT: To obtain the most accurate results, follow the instructions below accurately. Starting PoolMon changes the data, therefore you must let it run until it reaches a steady state and the data is reliable. This example outlines a procedure for using PoolMon to detect a memory leak:.Install PoolMon on the computer you want to test, following the Microsoft product instructions.Poolmon.exe is contained in Microsoft Windows Driver Kit (WDK).Type the following command and press ENTER:.Click Start, Run, type cmd, and press ENTER.Enable pool tagging by using the command line:.In the dialog box, enable Enable Pool Tagging.Enable pool tagging by using a dialog box:.If you are using Windows 2003 or later, skip to Step 2. If you are using XP, enable pool tagging as follows.You must enable Gflags.exe to enable pool tagging. Pool tagging is permanently enabled on Windows Server 2003 and later. IMPORTANT: This applies if you want to use PoolMon on Windows XP or earlier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |